- Color: Black
- Latest Firmware Version V1.39
- Support 2009 Models
- Support Saab 9-5 and Saab 9-3 CAN
- Covers almost all Opel cars from 1992 - 2008, even new cars with CAN-BUS based,diagnostic, such as Vectra-C, Astra-H, Zafira-B
- OP-COM is a PC based Opel diagnostic program
- This interface can read out and clear, fault codes, shows you live data, lets you to perform output test, and supports remote, and key programming
- The program supports many control units, such as:
- Engine
- Automatic Transmission
- ABS
- Airbag
- Engine Cooling module
- Instrument Cluster
- Electronic Climate Control
- Body Control Unit
- Since Opel uses many pin in the On-Board Diagnostic connector, the diagnostic interface works as a multiplexer, and selects the appropriate pin for communication
- PIN3, PIN7,PIN8,PIN12 = Serial Link (ISO9141, KW81, KW82, KWP2000)
- PIN6-PIN14
- PIN3-PIN11
- PIN1
- HSCAN - Dual-wire, High Speed CAN-BUS, 500 kbps
- MSCAN - Dual-wire, Medium Speed CAN-BUS, 95 kbps
- SWCAN - Single-wire, Low Speed CAN-BUS, 33.3 kbps
- The diagnostic inteface is USB port based, so there will be NO COMPATIBILITY ISSUES, with serial to USB converters
- The speed of the communication over the USB-BUS is enough to handle the awesome speed of the High-Speed CAN-BUS systems, which is currently 500kbps. This is the main reason, why only the USB port based interface is available for CAN-BUS
- NOTE: The program can only be used with a special interface hardware. A simple serial or USB port based standard interfaces (K, KKL, etc) cannot be used
- Comes with USB cable (140cm) and software CD